No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the BGP Route Receiving and Advertisement Configuration

Verifying the BGP Route Receiving and Advertisement Configuration

Procedure

  • Run the display ip as-path-filter [ as-path-filter-number | as-path-filter-name ] command to check information about a configured AS_Path filter.
  • Run the display ip community-filter [ basic-comm-filter-num | adv-comm-filter-num | comm-filter-name ] command to check information about a configured community filter.
  • Run the display ip extcommunity-filter [ extcomm-filter-number | extcomm-filter-name ] command to check information about a configured extended community filter.
  • Run the display bgp routing-table as-path-filter { as-path-filter-number | as-path-filter-name } command to check information about routes matching a specified AS_Path filter.
  • Run the display bgp routing-table community-filter { { community-filter-name | basic-community-filter-number } [ whole-match ] | advanced-community-filter-number } command to check information about routes matching a specified BGP community filter.
  • Run the display bgp routing-table peer ipv4-address received-routes [ active ] [ statistics ] command to check information about routes received by a BGP device from its peers.
  • Run the display bgp multicast routing-table different-origin-as command to check information about MBGP routes with different origin ASs.
  • Run the display bgp multicast routing-table regular-expression as-regular-expression to check information about MBGP routes matching the AS regular expression.
  • Run the display bgp multicast paths [ as-regular-expression ] command to check information about AS paths.
  • Run the display bgp multicast routing-table as-path-filter { as-path-filter-number | as-path-filter-name } command to check information about MBGP routes matching the AS_Path filter.
  • Run the display bgp multicast routing-table community-filter { { community-filter-name | basic-community-filter-number } [ whole-match ] | advanced-community-filter-number } command to check information about routes matching a specified MBGP community filter.
  • Run the display bgp multicast routing-table peer peer-address { advertised-routes [ network [ { mask | mask-length } [ longer-prefixes ] ] ] | received-routes [ active ] | accepted-routes } command to check information about routes that are sent by and received from the specified MBGP peer.
  • Run the display bgp multicast network command to check the routing information that MBGP advertises.
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 311197

Downloads: 1098

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next