No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
IS-IS Overload

IS-IS Overload

IS-IS Overload allows a device to use the IS-IS overload bit to identify the overload state. The IS-IS overload bit is the OL field in an IS-IS LSP. After the overload bit is set on a device, other devices ignore this device when performing SPF calculation and consider only the direct routes of the device.

Figure 8-10  IS-IS Overload

As shown in Figure 8-10, RouterB forwards the packets sent from RouterA to network segment 10.1.1.0/24. If the overload bit in the LSP sent from RouterB is set to 1, RouterA considers the LSDB of RouterB incomplete and sends packets to 10.1.1.0/24 through RouterD and RouterE. This process does not affect the packets sent to the directly connected network segment of RouterB.

If a device cannot store new LSPs and fails to synchronize the LSDB, the routes calculated by this device are incorrect. In this situation, the device enters the overload state and does not calculate the routes passing through this device; however, the direct routes of the device are still valid.

A device may enter the overload state because of device abnormalities or is manually configured to enter the overload state. When an IS-IS device on the network needs to be upgraded or maintained, isolate this device from the network temporarily and set the overload bit on the device to prevent other devices from using this device to forward traffic.
NOTE:
  • If the system enters the overload state because of an abnormality, the system deletes all the imported or leaked routes.
  • If the system is configured to enter the overload state, the system determines whether to delete all the imported or leaked routes based on the configuration.
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 335912

Downloads: 1156

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next