No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the RIP Version

(Optional) Configuring the RIP Version

Context

RIP versions include RIP-1 and RIP-2. The RIP version must be configured on the device running RIP. Configure the global RIP version unless you need to specify a different RIP version on an interface.

Procedure

  • Configure the global RIP version.
    1. Run system-view

      The system view is displayed.

    2. Run rip [ process-id ]

      The RIP view is displayed.

    3. Run version { 1 | 2 }

      The global RIP version is configured.

      NOTE:

      By default, an interface sends only RIP-1 packets and receives both RIP-1 and RIP-2 packets.

  • Configure the RIP version on an interface.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.
      NOTE:

      Only the S5720HI, S5720EI, S6720EI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.

    4. Run rip version { 1 | 2 [ broadcast | multicast ] }

      The RIP version is configured on the interface.

      NOTE:
      • By default, an interface sends only RIP-1 packets and receives both RIP-1 and RIP-2 packets.
      • If no RIP version is configured in the interface view, the global RIP version is used. The RIP version configured on an interface takes precedence over the global RIP version.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 312752

Downloads: 1106

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next