No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Additional Metrics of an Interface

Configuring Additional Metrics of an Interface

Context

Configuring additional metrics on a RIP interface can change the route selection sequence.

The additional metric is the metric (hop count) to be added to the original metric of a RIP route. You can use commands to set additional metrics for incoming and outgoing RIP routes.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.
    NOTE:

    Only the S5720HI, S5720EI, S6720EI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.

  4. Run the following commands as required:

    • Run the rip metricin { value | { acl-number | acl-name acl-name | ip-prefix ip-prefix-name } value1 } command to set the additional metric for receiving routes.
    • Run the rip metricout { value | { acl-number | acl-name acl-name | ip-prefix ip-prefix-name } value1 } command to set the additional metric for advertising routes.
    NOTE:
    • The rip metricin command is used to add an additional metric to an incoming route. After this route is added to the routing table, its metric in the routing table changes. Running this command affects route selection on the local device and other devices on the network.
    • The rip metricout command is used to add an additional metric to an outgoing route. When this route is advertised, an additional metric is added to this route, but the metric of the route in the routing table does not change. Running this command does not affect route selection on the local device but affects route selection on other devices in the network.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 329197

Downloads: 1146

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next