No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Route Summarization

Route Summarization

The BGP routing table of each device is large on large networks. This burdens devices, increases the route flapping probability, and affects network stability.

Route summarization is a mechanism that combines multiple routes into one route. This mechanism allows a BGP device to advertise only the summarized route but not all the specific routes to peers, thereby reducing the size of the BGP routing table. If the summarized route flaps, the network is not affected, improving network stability.

BGP supports automatic summarization and manual summarization on IPv4 networks, and supports only manual summarization on IPv6 networks. Automatic and manual summarization work as follows:

  • Automatic summarization

    Summarizes the routes imported by BGP. After automatic summarization is configured, BGP summarizes routes based on the natural network segment and advertises only the summarized route to peers. For example, BGP summarizes 10.1.1.1/24 and 10.2.1.1/24 (two Class A addresses with non-natural mask) into 10.0.0.0/8 (Class A address with natural mask).

  • Manual summarization

    Summarizes routes in the local BGP routing table. Manual summarization can help control the attributes of the summarized route and determine whether to advertise specific routes.

To prevent routing loops caused by route summarization, BGP uses the AS_Set attribute. The AS_Set attribute is an unordered set of all ASs that a route passes through. When the summarized route enters an AS in the AS_Set attribute again, BGP finds that the local AS number has been recorded in the AS_Set attribute of the route and discards this route to prevent a routing loop.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 310928

Downloads: 1094

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next