No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic BGP Function Configuration

Verifying the Basic BGP Function Configuration

Procedure

  • Run the display bgp peer [ verbose ] command to check information about all BGP peers.
  • Run the display bgp peer ipv4-address { log-info | verbose } command to check information about the specified BGP peer.
  • Run the display bgp routing-table [ ipv4-address [ { mask | mask-length } [ longer-prefixes ] ] ] command to check BGP routing information.
  • Run the display bgp group [ group-name ] command to check information about the specified BGP peer group.
  • Run the display bgp multicast peer [ [ peer-address ] verbose ] command to check information about the specified MBGP peer.
  • Run the display bgp multicast group [ group-name ] command to check information about an MBGP peer group.
  • Run the display bgp multicast network command to check the routing information that MBGP advertises.
  • Run the display bgp multicast routing-table [ ip-address [ mask-length [ longer-prefixes ] | mask [ longer-prefixes ] ] ] command to check the MBGP routing table.
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 311040

Downloads: 1094

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next