No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Convergence Priorities for IS-IS Routes

Configuring Convergence Priorities for IS-IS Routes

Context

You can configure the highest convergence priority for specific IS-IS routes so that these IS-IS routes will be converged first when a network topology changes.

The application rules of the convergence priorities for IS-IS routes are as follows:
  • Existing IS-IS routes are converged based on the priorities configured in the ipv6 prefix-priority command.

  • New IS-IS routes are converged based on the priorities configured in the ipv6 prefix-priority command.

  • If an IS-IS route conforms to the matching rules of multiple convergence priorities, the highest convergence priority is used.

  • The convergence priority of a Level-1 IS-IS route is higher than that of a Level-2 IS-IS route.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run isis [ process-id ]

    The IS-IS view is displayed.

  3. Run ipv6 prefix-priority [ level-1 | level-2 ] { critical | high | medium } { ipv6-prefix prefix-name | tag tag-value }

    Convergence priorities are set for IS-IS routes.

    By default, the convergence priority of 32-bit host routes is medium, and the convergence priority of the other IS-IS routes is low.

    NOTE:

    The ipv6 prefix-priority command is only applicable to the public network.

    After the ipv6 prefix-priority command is run, the convergence priority of 32-bit host routes is low, and the convergence priorities of the other routes are determined as specified in the ipv6 prefix-priority command.

  4. (Optional) Run quit

    The system view is displayed.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 337477

Downloads: 1157

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next