No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling Rapid EBGP Connection Reset

Disabling Rapid EBGP Connection Reset

Context

Rapid EBGP connection reset is enabled by default. This allows BGP to immediately respond to a fault on an interface and delete the direct EBGP sessions on the interface without waiting for the hold timer to expire and implements rapid BGP network convergence.

If the status of an interface used to establish an EBGP connection changes frequently, the EBGP session will be deleted and reestablished repeatedly, causing network flapping. Rapid EBGP connection reset can be disabled in such a situation. BGP will delete direct EBGP sessions on the interface until the hold timer expires. This suppresses BGP network flapping and reduces network bandwidth consumption.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run undo ebgp-interface-sensitive

    Rapid EBGP connection reset is disabled.

    By default, rapid EBGP connection reset is enabled.

    NOTE:

    Rapid EBGP connection reset enables BGP to quickly respond to interface faults but prevents BGP from quickly responding to interface recovery. After the interface recovers, BGP uses its state machine to restore relevant sessions.

    Rapid EBGP connection reset is disabled in a situation where the status of an interface used to establish an EBGP connection changes frequently. If the status of the interface becomes stable, run the ebgp-interface-sensitive command to enable rapid EBGP connection reset to implement rapid BGP network convergence.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 315125

Downloads: 1110

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next