No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for RIP

Default Settings for RIP

Table 4-4 describes the default settings for RIP.

Table 4-4  Default settings for RIP
Parameter Default Setting
Maximum number of equal-cost routes

By default, the maximum number of equal-cost routes on the S6720SI, S6720S-SI, S5730SI, S5730S-EI, S5720S-SI or S5720SI is 8, and the maximum number of equal-cost routes on the S5720EI, S5720HI, S6720S-EI, or S6720EI is 16.

RIP function Disabled
Split horizon Enabled
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 318026

Downloads: 1123

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next