Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configure BGP Auto FRR
Context
On an intra-AS seamless MPLS network that has protection
switching enabled, if a link or node fails, traffic switches to a
backup path, which implements uninterrupted traffic transmission.![]()
If both LDP FRR and BGP Auto FRR functions are configured, only BGP Auto FRR takes effect.
Procedure
- Run system-view
The system view is displayed.
- Run bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
- Run ipv4-family unicast
The BGP-IPv4 unicast address family view is displayed.
- Run auto-frr
BGP Auto FRR is enabled for IPv4 unicast routes.
- Run bestroute nexthop-resolved tunnel
Labeled BGP IPv4 unicast routes can participate in route selection only when their next hops are iterated to tunnels.
- (Optional) Run ingress-lsp protect-mode bgp-frr
BGP FRR is enabled for BGP LSPs.
Perform this step on each CSG and MASG to enable the protection switching function for the whole BGP LSP.
