Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MPLS TE
Procedure
- Run system-view
The system view is displayed.
- Run mpls
The MPLS view is displayed.
- Run mpls te
MPLS TE is enabled on the node globally.
- Run quit
Return to the system view.
- Run interface interface-type interface-number
The view of the interface is displayed.
- (Optional) On an Ethernet interface, run undo portswitch
The interface is switched to Layer 3 mode.
By default, an Ethernet interface works in Layer 2 mode.Only the S5720HI, S5720EI, S6720EI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.
- Run mpls
The MPLS is enabled on the interface.
- Run mpls te
The MPLS TE is enabled on the interface.
