Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Dynamic BFD for LDP LSPs
Procedure
- Run the display bfd configuration all [ verbose ] command to check the BFD configuration (ingress).
- Run the display bfd configuration passive-dynamic [ peer-ip peer-ip remote-discriminator discriminator ] [ verbose ] command to check the BFD configuration (egress).
- Run the display bfd session all [ verbose ] command to check information about the BFD session (ingress).
- Run the display bfd session passive-dynamic [ peer-ip peer-ip remote-discriminator discriminator ] [ verbose ] command to check information about the BFD established passively (egress).
- Run the display mpls bfd session [ statistics | protocol ldp | outgoing-interface interface-type interface-number | nexthop ip-address | fec fec-address | verbose | monitor ] command to check information about MPLS BFD session (ingress).
