Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of Dynamic BFD for CR-LSPs
Procedure
- Run the display bfd configuration dynamic [ verbose ] command to check the configuration of dynamic BFD on the ingress.
- Run the display bfd configuration passive-dynamic [ peer-ip peer-ip remote-discriminator discriminator ] [ verbose ] command to check the configuration of dynamic BFD on the egress.
- Run the display bfd session dynamic [ verbose ] command to check information about the BFD session on the ingress.
- Run the display bfd session passive-dynamic [ peer-ip peer-ip remote-discriminator remote-discr-value ] [ verbose ] command to check information about the BFD session passively created on the egress.
- Check the BFD statistics.
- Run the display bfd statistics command to check statistics about all BFD sessions.
- Run the display bfd statistics session dynamic command to check statistics about dynamic BFD sessions.
- Run the display mpls bfd session [ fec fec-address | monitor | nexthop ip-address | outgoing-interface interface-type interface-number | statistics | verbose ] or display mpls bfd session protocol { cr-static | rsvp-te } [ lsp-id ingress-lsr-id session-id lsp-id [ verbose ] ] command to check information about BFD sessions.
