Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Auto Bypass Tunnel Re-Optimization
Context
Network changes often cause the changes in optimal paths. Auto Bypass tunnel re-optimization allows paths to be recalculated at certain intervals for an auto bypass tunnel. If an optimal path to the same destination is found due to some reasons, such as the changes in the cost, a new auto bypass tunnel will be set up over this optimal path. In this manner, network resources are optimized.
Perform the following configurations on the PLR.
Procedure
- Run system-view
The system view is displayed.
- Run mpls
The MPLS view is displayed.
- Run mpls te auto-frr reoptimization [ frequency interval ]
Auto bypass tunnel re-optimization is enabled.
By default, auto bypass tunnel re-optimization is disabled. If re-optimization is enabled, the default interval at which auto bypass tunnel re-optimization is performed is 3600 seconds.
- (Optional) Immediately re-optimize the TE tunnels.
