No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S1720, S2700, S5700, and S6720 V200R011C10

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, and NETCONF.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Path Jitter Test

Path Jitter Test

The UDP jitter test measures delay and jitter on the path from the source to the destination, but cannot determine the failure point on the network. When jitter is too high, the path jitter test can determine the hop that causes the high jitter.

The NQA path jitter test obtains the hop-by-hop IP addresses from the source to the destination by initiating a trace test, and then carries out an ICMP jitter test from the source to obtain the jitter value of each hop along the path.

The process of a path jitter test is as follows:

  1. The source (SwitchA) initiates a trace test to the destination (SwitchC) to obtain the IP address of each hop along the path.

  2. The source initiates an ICMP jitter test to obtain the jitter value of each hop along the path to the destination.

Figure 7-15  Application scenario of a path jitter test

Path jitter test results and historical records are stored in test instances. You can run commands to view the path jitter test results and historical records.

Translation
Download
Updated: 2020-02-06

Document ID: EDOC1000178174

Views: 207739

Downloads: 825

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next