No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

S1720, S2700, S5700, and S6720 V200R011C10

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, and NETCONF.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MAC Ping Test

MAC Ping Test

The NQA Media Access Control (MAC) ping test is a detection tool provided by Ethernet Operations, Administration, and Maintenance (OAM) and is implemented according to IEEE 802.1ag.

A MAC ping test is initiated by a maintenance association end point (MEP) and is performed between the MEP and Maintenance Point (MP) in the same Maintenance Association (MA). The destination is an MEP or Maintenance association Intermediate Point (MIP) of the same level as the MEP initiating the MAC ping test in the same or different MAs.

The S1720GFR does not support MAC ping test.

The process of initiating an 802.1ag MAC ping test from MEP1 to MEP2 is as follows:

  1. MEP1 sends a Loopback Message (LBM) to MEP2.

  2. MEP2 receives the LBM and responds with a Loopback Reply (LBR).

  3. MEP1 calculates the time taken to perform the ping operation to analyze network performance.

    Within the timeout period:

    • If MEP1 does not receive the LBR message from MEP2, it considers the link between itself and MEP2 unreachable.

    • If MEP1 receives the LBR message from MEP2, it calculates the transmission delay from MEP1 to MEP2 based on the timestamps in the message.

    During a MAC ping test, the source can send multiple LBMs continuously and then check whether LBRs are returned. This test allows the collection of statistics about Ethernet OAM performance, including the average delay, jitter, and packet loss ratio, based on the timestamps in the test packets.

Figure 7-11  Network for MAC ping test

MAC ping test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Updated: 2020-02-06

Document ID: EDOC1000178174

Views: 208167

Downloads: 825

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next