No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Network Management and Monitoring

S1720, S2700, S5700, and S6720 V200R011C10

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, and NETCONF.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling NetStream Flexible Flow Statistics Collection on an Interface

Enabling NetStream Flexible Flow Statistics Collection on an Interface

Context

When configuring flexible NetStream, you must enable flow statistics collection and apply a flexible flow statistics template on an interface to ensure that statistics are exported successfully.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the interface interface-type interface-number command to enter the interface view.
  3. Run the port ip netstream record record-name command to apply the flexible flow statistics template to the interface.

    • Each interface can be configured with only one flexible flow statistics template. Before modifying the flexible flow statistics template in the same interface view, run the undo port ip netstream record command to delete the existing configuration.

    • If the flexible flow statistics template has been applied to the interface, the template configuration cannot be modified or deleted.

  4. Enable flow statistics collection function on an interface.
    1. Run the ip netstream { inbound | outbound } command to enable the NetStream function on the interface to collect statistics about IPv4 flows.
    2. Run the ipv6 netstream { inbound | outbound } command to enable the NetStream function on the interface to collect statistics about IPv6 flows.

      By default, IPv4 and IPv6 flow statistics are not collected.

      • When the IPv4 and IPv6 flow statistics collection function is enabled on the interface, statistics about unicast and multicast packets are collected.

      • After the statistics collection function is enabled for IPv4 and IPv6 flows, the statistics are independent of each other.

Translation
Download
Updated: 2020-02-06

Document ID: EDOC1000178174

Views: 208170

Downloads: 825

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next