No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

S1720, S2700, S5700, and S6720 V200R011C10

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, and NETCONF.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Trace Test

Trace Test

The NQA trace test detects the forwarding path between the source and the destination and collects statistics about each device along the forwarding path. It has a similar function to the tracert command, but provides more output information, including:

  • Average delay
  • Packet loss ratio
  • Time of receiving the last packet

The trace test process is as follows:

  1. The source (SwitchA) constructs a UDP packet, with the time-to-live (TTL) set to 1 and sends it to the destination (SwitchD).

  2. When the first-hop router (SwitchB) receives the UDP packet, its TTL decreases to 0. The first-hop router discards the UDP packet and returns an ICMP Time Exceeded packet.

  3. The source obtains the IP address of the first-hop router from this ICMP Time Exceeded packet. It then constructs another UDP packet with the TTL set to 2.

  4. When the second-hop router (SwitchC) receives the UDP packet, its TTL decreases to 0. The second-hop router discards the UDP packet and returns an ICMP Time Exceeded packet.

  5. The source continues to send UDP packets, with the TTL increasing by 1 each time. This process is repeated until the packet reaches the destination, which then returns an ICMP Port Unreachable packet to the source.

The ICMP packets from each hop give the source information about the forwarding path as well as statistics about each device along the path.

Figure 7-8  Network for Trace test

Trace test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Updated: 2020-02-06

Document ID: EDOC1000178174

Views: 208417

Downloads: 826

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next