No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Network Management and Monitoring

S1720, S2700, S5700, and S6720 V200R011C10

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, NetStream, sFlow, TWAMP Light, and NETCONF.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Device to Communicate with an NMS Through SNMPv3

Configuring a Device to Communicate with an NMS Through SNMPv3


To allow a device to communicate with an NMS through SNMPv3, configure SNMPv3 on the device. The SNMP parameters must be configured on both the managed device (agent) and NMS. This section describes only the SNMP configurations on the agent side. For details about SNMP configurations on an NMS, see the NMS operation guide.

Pre-configuration Tasks

Before configuring a device to communicate with an NMS through SNMPv3, configure a routing protocol to ensure that at least one route exists between switch and NMS.

Configuration Procedure

When you configure the device to communicate with the NMS using SNMPv3, only basic functions from Configuring Basic SNMPv3 Functions are mandatory. The other steps are optional and can be performed in any sequence.

After the basic SNMP functions are configured, the NMS can communicate with managed devices.
  • The NMS using the specified community name can access the ViewDefault view, in which the internet MIB (OID: can be operated.

  • The managed device sends traps generated by the modules that are enabled by default to the NMS.

The following are optional SNMPv3 configurations to implement refined management:
Updated: 2020-02-06

Document ID: EDOC1000178174

Views: 209203

Downloads: 827

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next