No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, MPAC, separating the management plane from the service plane, security risks, PKI.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring ARP Gateway Protection

Configuring ARP Gateway Protection

Context

If an attacker poses as a gateway to send ARP packets, other users on the network consider the attacker to be a gateway, causing a communication interruption between authorized users and gateway. This situation will also happen if a user incorrectly sets the host IP address as the gateway address. To prevent such bogus gateway attacks, configure ARP gateway protection on the device's interfaces connected to the gateway. When the ARP packets from a gateway address reach a device:
  • The interfaces with gateway protection enabled can receive and forward the ARP packets.
  • The interfaces without gateway protection enabled discard the ARP packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run arp trust source ip-address

    ARP gateway protection is enabled and the protected gateway IP address is set.

    By default, ARP gateway protection is disabled.

    A maximum of 8 protected gateway addresses can be specified on each interface, and 32 can be specified on the entire device. If the same gateway IP address is specified on different interfaces, the system considers that multiple protected gateway IP addresses have been configured.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178177

Views: 235128

Downloads: 758

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next