No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, MPAC, separating the management plane from the service plane, security risks, PKI.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing DHCP Snooping Binding Entries

Clearing DHCP Snooping Binding Entries

Context

After the networking environment changes, DHCP snooping binding entries do not age immediately. The following information in DHCP snooping binding entries may change, causing packet forwarding failure:
  • VLAN to which a DHCP client belongs.
  • Interface to which DHCP clients are connected.
Before changing the networking environment, clear all DHCP snooping binding entries manually so that the device generates a new DHCP snooping binding table based on the new networking environment.

After the DHCP snooping binding entries are cleared, network communication can be recovered only after all the DHCP users connected to the device re-log in and new binding entries are generated. Exercise caution when you run the command.

Procedure

  • In the user view, run the following commands to clear DHCP snooping binding entries:

    • reset dhcp snooping user-bind [ vlan vlan-id | interface interface-type interface-number ] * [ ipv4 | ipv6 ]
    • reset dhcp snooping user-bind [ ip-address [ ip-address ] | ipv6-address [ ipv6-address ] | vpls vpls-name ]
    • reset dhcp snooping user-bind [ ipv6-prefix [ prefix/prefix-length ] ]
    NOTE:

    The parameter vpls vpls-name is only supported by the S5720HI.

Translation
Download
Updated: 2019-09-23

Document ID: EDOC1000178177

Views: 231811

Downloads: 746

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next