No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, MPAC, separating the management plane from the service plane, security risks, PKI.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applying an Attack Defense Policy

Applying an Attack Defense Policy

Context

Packets sent to the CPU pass through the switching chip before they reach the CPU, as shown in Figure 3-3. Therefore, an attack defense policy is usually applied to the switching chip of a switch by specifying the global keyword.

Figure 3-3  Path of packets sent to the CPU

In a stack system shown in Figure 3-4, applying an attack defense policy to the CPU of the master switch by not specifying the global keyword. If you only limit packet rates on switching chips of member switches, the CPU of the master switch may still be overloaded by a large number of protocol packets, because most protocol packets need to be sent to the CPU of the master switch after being processed by the CPU of the standby switch or a slave switch. Applying an attack defense policy to the CPU of the master switch can limit the rates of protocol packets sent to this CPU, protecting the CPU from attacks.

Figure 3-4  Path of packets sent to CPUs in a stack system

Procedure

  • Apply a attack defense policy to the CPU.

    1. Run the system-view command to enter the system view.
    2. Run the cpu-defend-policy policy-name1 command to apply an attack defense policy.
    NOTE:

    In a stack system, some protocol packets are not sent to the CPU of the master switch. If you apply an attack defense policy against such protocol packets to the CPU, the system displays an error message, indicating that the policy cannot be applied.

    Only the attack defense policies that limit the rates of packets sent to the CPU can be applied to the CPU. Other types of attack defense policies are not applicable to the CPU, so configuring such policies cannot protect the CPU.

  • Apply an attack defense policy to the switching chip.

    1. Run the system-view command to enter the system view.
    2. Run the cpu-defend-policy policy-name2 global command to apply an attack defense policy.

Translation
Download
Updated: 2019-03-28

Document ID: EDOC1000178177

Views: 223189

Downloads: 720

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next