No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, MPAC, separating the management plane from the service plane, security risks, PKI.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DAI Is Enabled on a Switch, and the Source MAC Address of an ARP Packet Is Checked Against the Source MAC Address in an Ethernet Frame Header. An ARP Packet with its Source MAC Address Different from that in the Ethernet Frame Header Can Pass the Check. Why?

DAI Is Enabled on a Switch, and the Source MAC Address of an ARP Packet Is Checked Against the Source MAC Address in an Ethernet Frame Header. An ARP Packet with its Source MAC Address Different from that in the Ethernet Frame Header Can Pass the Check. Why?

In earlier versions of V200R001, a DAI-enabled switch checks ARP packets based on ACL rules delivered to the chip. However, the ARP packet must be sent to the CPU, and the check of the source MAC address in the ARP packet and that in the Ethernet frame header is performed by software. After the DAI check, the packet is not sent to the CPU, so the source MAC address in the ARP packet and that in the Ethernet frame header are not checked.

In V200R001 and later versions, a DAI-enabled switch checks ARP packets using software. The ARP packet with its source MAC address different from that in the Ethernet frame header is discarded.

Translation
Download
Updated: 2019-03-28

Document ID: EDOC1000178177

Views: 222759

Downloads: 720

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next