No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Security

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of Security, including ACL, local attack defense, MFF, attack defense, traffic suppression and storm control, ARP security, Port security, DHCP snooping, ND snooping, PPPoE+, IPSG, SAVI, URPF, keychain, MPAC, separating the management plane from the service plane, security risks, PKI.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Can I Prevent ARP Attacks Targeted at Static Users?

How Can I Prevent ARP Attacks Targeted at Static Users?

Static users (for example, dumb terminals such as printers and servers) are allocated static IP addresses. Attackers usually steal authorized users' IP addresses to connect to networks and initiate ARP attacks to interrupt network communication.

To defend against ARP attacks, a static user binding table and dynamic ARP inspection (DAI) can be configured for static users. DAI checks ARP packets based on binding entries.

Run the user-bind static command to configure the static user binding table, and run the arp anti-attack check user-bind enable command to enable DAI.

After the configuration, when a device receives an ARP packet, it compares the source IP address, source MAC address, interface number, and VLAN ID of the ARP packet with static binding entries. If the ARP packet matches a binding entry, the device considers the ARP packet valid and allows the packet to pass through. If the ARP packet does not match a binding entry, the device considers the ARP packet invalid and discards the packet.

Translation
Download
Updated: 2019-03-28

Document ID: EDOC1000178177

Views: 221962

Downloads: 720

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next