No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Basic Configuration

S7700 and S9700 V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Batch Configuration

Batch Configuration

On a network supporting EasyDeploy shown in Figure 2-10, all the clients require the same configurations. This section describes the batch configuration process.

Figure 2-10  Networking for batch configuration
  1. The network administrator makes a command line script locally and uploads the script to the Command, or edits a command line script on the Commander directly.
  2. The network administrator specifies on the Commander the clients or groups to which commands need to be issued and executes the command line script.
  3. After the clients receive the commands from the Commander, they execute the commands and saves the command execution results.
  4. The network administrator can check the command execution results on the Commander.

Figure 2-11 shows the interaction between the Commander and a client after the administrator executes the command line script.

Figure 2-11  Interaction between the Commander and a client
  1. The Commander sends a command issuing notification to the client.
  2. After the client receives the notification, it sends a request to the Commander to obtain command lines.
  3. After the Commander receives the request, it sends the commands to the client.
  4. The client executes the commands and saves the command execution results.
  5. The Commander sends a request to the client to query the command execution results.
  6. The client responds with the command execution results.
Updated: 2020-02-04

Document ID: EDOC1000178308

Views: 100485

Downloads: 152

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next