No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - Basic Configuration
S7700 and S9700 V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Uploading and Loading a Web Page File

Uploading and Loading a Web Page File


The system software of the switch contains a web page file, and the web page file is pre-loaded to the switch before delivery. If you use this web page file, you do not need to perform the following configuration. To upgrade the web page file on the switch, log in to Huawei official website to download an independent web page file, upload and load the file to the switch.

To obtain a web page file, log in to the Huawei enterprise support website (, choose the product model and version, and select a patch version under Public Patch in V and R Version to download the required web page file. The file name is in the format of product name-software version number.web page file version number.web.7z.

After downloading the file, compare the downloaded web page file with that on the website to check whether their sizes are the same. If not, an error may occur during file download. Download the file again.

Each web page file corresponds to a signature file. The method of downloading the signature file is the same as that of downloading the web page file.


  1. Upload the web page file.

    You can upload the web page file using SFTP or other modes. For details, see Local File Management.

    After the file is uploaded to the switch, run the dir command in the user view to check whether the uploaded file has the same size as that on the file server. If not, an error may occur during file upload. Upload the file again.

  2. (Optional) Run check file-integrity filename signature-filename

    The web page file validity is checked.

  3. Load the web page file.
    1. Run system-view

      The system view is displayed.

    2. Run http server load { file-name | default }

      The web page file is loaded.

      By default, the web page file in system software is pre-loaded on the switch.

      If default is specified, the web page file in the system software is loaded. If file-name is specified, an independent web page file is loaded.

      If the system software is upgraded from V200R006 or an earlier version to V200R007 or a later version, but the target software version conflicts with the configuration file for next startup, the switch will cancel the configuration of loading the web page file in the original system software after the upgrade, and load the web page file integrated in the new system software by default.

Updated: 2020-02-04

Document ID: EDOC1000178308

Views: 109397

Downloads: 152

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next