No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Basic Configuration

S7700 and S9700 V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Device Through STelnet

Logging In to a Device Through STelnet


After completing SSH user and STelnet server configurations on a device, you can use STelnet software on a PC to log in to the device. Assume that password authentication is configured for SSH users and the management IP address of the device is The third-party software, PuTTY, is used as an example to illustrate the STelnet login process.


  1. Start the PuTTY software, enter the device's IP address, and select the SSH protocol.

    Figure 5-5  Logging in to an SSH server through PuTTY in password authentication mode

  2. Click Open. In the displayed page, enter the user name and password and press Enter to log in to the device through STelnet.

    login as: client001      //Enter the SSH user name.
    Sent username "client001"
    client001@'s password:           //Enter the password configured through AAA.
    Info: The max number of VTY users is 21, and the number
          of current VTY users on line is 5.
          The current login time is 2012-08-06 09:35:28+00:00.

Verifying the Configuration

  • Run the display ssh user-information [ username ] command to check information about SSH users on the SSH server. If no SSH user is specified, information about all SSH users logging in to the SSH server is displayed.
  • Run the display ssh server status command to check global configurations of the SSH server.
  • Run the display ssh server session command to check information about sessions between the SSH server and client.
Updated: 2020-02-04

Document ID: EDOC1000178308

Views: 101254

Downloads: 152

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next