No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Link Type for a Port

Setting the Link Type for a Port

Context

P2P links can implement rapid convergence. If the two ports connected to a P2P link are root or designated ports, the ports can transit to the forwarding state quickly by sending Proposal and Agreement packets. This reduces the forwarding delay.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of an Ethernet interface participating in STP calculation is displayed.

  3. Run stp point-to-point { auto | force-false | force-true }

    The link type is set for the interface.

    By default, an interface automatically identifies whether it is connected to a P2P link. P2P links implement rapid network convergence.

    • If the Ethernet interface works in full-duplex mode, the interface is connected to a P2P link. In this case, force-true can be specified in the command to implement rapid network convergence.

    • If the Ethernet interface works in half-duplex mode, you can run the stp point-to-point force-true command to forcibly set the link type to P2P.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 287831

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next