No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switches Are Connected Across a Transmission Device Using Link Aggregation

Switches Are Connected Across a Transmission Device Using Link Aggregation

As shown in Figure 3-14, a transmission device needs to be deployed between two switches that are far away from each other. In addition, link aggregation is configured between the two switches to enhance link bandwidth and reliability.

  • The switches at both ends must use link aggregation in LACP mode.
  • The transmission device between switches must be configured to transparently transmit LACPDUs.
Figure 3-14  Switches are connected across a transmission device using link aggregation
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 298039

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next