No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the LDT Configuration

Verifying the LDT Configuration

Procedure

  1. Run the display loop-detection [ interface interface-type interface-number ] command to check the LDT configuration and interface status.

    If interface-type and interface-number are not specified, the status of the global LDT function is displayed. If the function is enabled, the system displays the interval for sending LDT packets, ID of the VLANs with this function enabled, detected loops, and actions taken on the interfaces where loops are detected.

    If interface-type and interface-number are specified, the system displays the interface status, interface recovery time, and LDT-enabled VLAN.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 296684

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next