No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Voice VLAN Typical Networking

Voice VLAN Typical Networking

As shown in Figure 9-1, a PC and an IP phone connect to a switch interface simultaneously. Therefore, the switch interface transmits both voice and data services.
Figure 9-1  Connecting a PC and an IP phone to a switch

The connection mode in Figure 9-1 is widely used on networks.

Figure 9-2 shows another connection mode, in which only an IP phone connects to a switch interface.
Figure 9-2  Connecting an IP phone to a switch

Some IP phones (for example, Cisco 7962) send tagged voice packets and some IP phones (for example, Huawei MC850) send untagged voice packets. The following sections describe how the MAC address-based voice VLAN and VLAN ID-based voice VLAN transmit tagged and untagged voice packets.

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 287173

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next