No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Separate VLAN for a Subordinate VLAN

Configuring a Separate VLAN for a Subordinate VLAN


A VLAN associated with separate interfaces is called a separate VLAN. Interfaces in a separate VLAN cannot communicate with each other.


  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The view of a created principal VLAN is displayed.

  3. Run subordinate separate vlan-id

    A separate VLAN is configured for a subordinate VLAN.

    Only one separate VLAN can be configured for a principal VLAN.

    Group and separate VLANs in one MUX VLAN must use different VLAN IDs.

    The VLAN ID assigned to a separate VLAN cannot be used to configure a VLANIF interface, super-VLAN, or sub-VLAN. Additionally, it is not recommended that this VLAN ID be used to configure VLAN mapping and VLAN stacking.

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 288406

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next