No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of SEP Configuration Tasks

Summary of SEP Configuration Tasks

Table 17-8 lists the SEP configuration tasks.

Table 17-8  SEP configuration tasks
Item Description Task

Configure basic SEP functions.

After basic SEP functions are configured on devices, the devices start SEP negotiation. Interfaces that complete neighbor negotiations last are blocked to eliminate redundant links.

When logging in to nodes on a SEP semi-ring through Telnet to configure the nodes, note the following points:
  • VLANIF interfaces and their IP addresses need to be configured, because these nodes are Layer 2 devices. The VLANs to which these VLANIF interfaces correspond must be mapped to SEP protected instances.
  • Basic SEP functions need to be configured from the node at one end of the semi-ring to the node at the other end of the semi-ring.

Configuring SEP

Specify an interface to block.

In some cases, however, the negotiated blocked interface may not be the required one. You can specify an interface to block according to network requirements.

Specifying an Interface to Block

Configure SEP multi-instance.

To implement load balancing and to use of bandwidth efficiently, protected instances need to be deployed on a SEP network and mapped to VLANs.

Configuring SEP Multi-Instance

Configure the topology change notification function.

A SEP network must work together with another network that runs other features. If the topology of one network changes, the other network must be able to detect the topology change and take measures to ensure reliable data transmission. Therefore, the topology change notification function must be enabled on the SEP network to ensure network reliability.

Configuring the Topology Change Notification Function

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 297984

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next