No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Why Is the CPU Usage High When VLANs Are Created or Deleted Through GVRP in Default Configuration?

Why Is the CPU Usage High When VLANs Are Created or Deleted Through GVRP in Default Configuration?

The switch supports VLAN configuration on devices at both ends. When GVRP is enabled on the network, it advertises information about dynamic VLANs in two directions. Then the intermediate devices dynamically create and delete VLANs based on the information. Dynamic maintenance of VLANs can greatly reduce manual configurations.

The maximum 4 K dynamic VLANs are frequently created and deleted, which triggers larger amount of packet communication. Receiving packets and delivering dynamic VLANs occupy large amount of CPU resources.

In actual networking, you need to adjust GVRP timers to the recommended values.

The recommended values of the GVRP timers are as follows:

GARP Hold timer: 100 centiseconds (1 second)

GARP Join timer: 600 centiseconds (6 seconds)

GARP Leave timer: 3000 centiseconds (30 seconds)

GARP LeaveAll timer: 12,000 centiseconds (2 minutes)

When more than 100 dynamic VLANs are created, use the preceding recommended values. When the number of dynamic VLANs increases, lengths of the GARP timers need to be increased.

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 298017

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next