No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Root Protection on a Port

Configuring Root Protection on a Port

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of an interface participating in STP calculation is displayed.

  3. Run stp root-protection

    Root protection is enabled on the interface.

    By default, root protection is disabled on the interface. Root protection takes effect only on designated ports. Generally, root protection is configured on the interfaces of the root bridge.

    Root protection and loop protection cannot be configured on the same interface.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 286268

Downloads: 141

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next