No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Automatic LBDT

Configuring Automatic LBDT

LBDT technology detects loops. To enable the switch to detect loops in the VLAN specified by the PVID or in the VLAN where MAC address flapping is detected, you can configure automatic LBDT. Then the switch can immediately detect loops on the downstream network or between two interfaces and send traps to notify users to minimize the impact of loops on the switch or the network.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 289892

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next