No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Creating a Ring Group

(Optional) Creating a Ring Group

Context

To reduce the number of received and sent Edge-Hello packets, you can use a ring group, in which a group of sub-rings with the same configuration of edge nodes or assistant edge nodes are added to the ring group.

Procedure

  1. On the edge node or assistant edge node, run system-view

    The system view is displayed.

  2. Run rrpp ring-group ring-group-id

    A ring group is created.

    A ring group can be created only on an edge node or an assistant edge on a sub-ring.

    All the sub-rings in a ring group must be on nodes of the same type, for example, all the sub-rings are located on edge nodes or assistant edge nodes.

  3. Run domain domain-id ring { ring-id1 [ to ring-id2 ] } &<1-10>

    Sub-rings are added to the ring group.

    Sub-rings in the same ring group share the same edge node, and the same assistant edge node.

    A sub-ring can belong to only one ring group.

    When you add a sub-ring to a ring group or delete a sub-ring from the ring group, note the following points:

    • To add an activated sub-ring to a ring group, add the sub-ring to the ring group on the assistant edge node, and then perform the same operation on the edge node.

    • To delete an activated sub-ring from a ring group, delete the sub-ring from the ring group on the edge node, and then perform the same operation on the assistant edge node.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 301078

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next