No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Association Between SEP and CFM

Association Between SEP and CFM

Association between SEP and CFM can be configured on the edge devices on a SEP segment. When CFM detects a fault on the network at the aggregation layer, edge devices send CCMs to notify the fault to the Operation, Administration, and Maintenance (OAM) module. The SEP status of the interface associated with CFM then changes to Down.

Figure 17-17 shows a networking diagram of association between SEP and CFM.

Figure 17-17  Association between SEP and CFM

In Figure 17-17, LSW1 to LSW5 run SEP to implement redundancy protection switching at the access layer and display the topology. The interface associated with CFM is in the SEP segment.

When the SEP status of the interface associated with CFM goes Down, LSW2 must send a Flush-FDB packet to notify other nodes of the topology changes. After LSW3 receives the Flush-FDB packet, the blocked interface on LSW3 is unblocked and enters the Forwarding state. The interface sends a Flush-FDB packet to instruct the other nodes to update their MAC address and ARP tables. Therefore, the lower-layer network can then detect the faults on the upper-layer network, ensuring reliable service transmission.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 289907

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next