No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application of a Single Ring

Application of a Single Ring

To provide link backup and improve network reliability, you can construct a ring on the network.

Figure 18-20  Network of a single ring

In Figure 18-20, Transit 1, Transit 2, Transit 3, and Master constitute a single RRPP ring. Data traffic is transmitted along the path Transit 1 -> Transit 2 -> Master.

If RRPP detects a fault on the link between Transit 1 and Transit 2, Master unblocks its secondary interface and immediately instructs other nodes on the ring to re-learn MAC address entries and ARP entries. Traffic on the RRPP ring is then switched to the path Transit 1 -> Transit 3 -> Master.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 298196

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next