No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Enable and Disable MAC Address Flapping Detection?

How Do I Enable and Disable MAC Address Flapping Detection?

Version

Enable MAC Address Flapping Detection

Disable MAC Address Flapping Detection

Versions earlier than V200R001 support only MAC address flapping detection in a VLAN.

Run the loop-detect eth-loop alarm-only in the VLAN view.

Run the undo loop-detect eth-loop alarm-only in the VLAN view.

V200R001 and later versions support global MAC address flapping detection in all VLANs. By default, global MAC address flapping detection is enabled.

Run the mac-address flapping detection in the system view.

Run the undo mac-address flapping detection in the system view.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 285193

Downloads: 141

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next