No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a SEP Segment

Configuring a SEP Segment


A SEP segment is the basic unit of SEP. A SEP segment consists of interconnected Layer 2 switching devices configured with the same SEP segment ID and control VLAN ID.

After SEP is configured on a device, you can run the description command to configure the description of the SEP segment, including the SEP segment ID, to facilitate maintenance.


  1. Run system-view

    The system view is displayed.

  2. Run sep segment segment-id

    A SEP segment is created and the view of the SEP segment is displayed.

    The switch supports a maximum of 256 SEP segments, and each card supports a maximum of 48 SEP segments.

  3. (Optional) Run description text

    A description is configured for the SEP segment.

    By default, no description is configured for an SEP segment.

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 300098

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next