No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Defining Characteristic Information About a Layer 2 Protocol

(Optional) Defining Characteristic Information About a Layer 2 Protocol

Context

When non-standard Layer 2 protocol packets with a specified multicast destination MAC address need to be transparently transmitted on the backbone network, define Layer 2 protocol characteristics on the PE. Layer 2 protocol characteristics include the protocol name, Ethernet encapsulation format, destination MAC address, and MAC address that replaces the destination MAC address of Layer 2 protocol packets.

When defining Layer 2 protocol characteristics, do not use the following multicast MAC addresses to replace the destination MAC address of Layer 2 protocol packets:

  • Destination MAC addresses of BPDUs: 0180-C200-0000 to 0180-C200-002F
  • Destination MAC addresses of Smart Link packets: 010F-E200-0004
  • Special multicast MAC addresses: 0100-0CCC-CCCC and 0100-0CCC-CCCD
  • Common multicast MAC addresses that have been used on the switch

Perform the following operations on PEs.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run l2protocol-tunnel user-defined-protocol protocol-name protocol-mac protocol-mac [ encap-type { { ethernetii | snap } protocol-type protocol-type | llc dsap dsap-value ssap ssap-value } ] group-mac { group-mac | default-group-mac }

    Characteristic information about a Layer 2 protocol is defined.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 298300

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next