No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a QinQ Termination Sub-interface and Connecting It to an L2VPN

Configuring a QinQ Termination Sub-interface and Connecting It to an L2VPN

Pre-configuration Tasks

Before configuring a QinQ termination sub-interface and connecting it to an L2VPN, complete the following tasks:
  • Connect devices correctly.
  • Configure VLANs to which CEs belong and basic Layer 2 forwarding so that packets sent from CEs to PEs carry double VLAN tags.
  • Ensure that the device is not a VCMP client.

Configuration Process

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 299059

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next