No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for GVRP

Application Scenarios for GVRP

GVRP enables routers on a network to dynamically maintain and update VLAN information. With GVRP, you can adjust the VLAN deployment on the entire network by configuring only a few devices. Analyzing the topology and managing configurations are not necessary. In Figure 12-9, GVRP is enabled on all devices. Devices are interconnected through trunk interfaces and each trunk interface allows packets of all VLANs to pass. Using GVRP, you simply need to configure static VLANs 100 to 1000 on SwitchA and SwitchC. Other devices can then learn VLANs 100 to 1000 using GVRP.

Figure 12-9  Typical application of GVRP

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 287875

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next