No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling VLAN-based Layer 2 Protocol Transparent Transmission on an Interface

Enabling VLAN-based Layer 2 Protocol Transparent Transmission on an Interface

Context

Perform the following operations on PEs according to the type of Layer 2 protocol packets to be transparently transmitted.

NOTE:

The l2protocol-tunnel vlan and l2protocol-tunnel commands cannot specify the same protocol type on the same interface. Otherwise, the configurations conflict.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The user-side interface view is displayed.

  3. Run port link-type hybrid

    The link type of the interface is set to hybrid.

  4. Run port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }

    The interface is added to the specified VLANs in tagged mode.

    NOTE:
    • The range of VLAN IDs specified in this step must include VLAN IDs of Layer 2 protocol packets from user networks.

    • The VLAN for VLAN-based Layer 2 protocol transparent transmission must be the static VLAN, and cannot be the VLAN dynamically created by GVRP and VCMP.

  5. Run l2protocol-tunnel { all | protocol-type | user-defined-protocol protocol-name } vlan { low-id [ to high-id ] } &<1-10>

    VLAN-based Layer 2 protocol transparent transmission is enabled on the interface.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 299479

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next