No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Delete Member Interfaces from an Eth-Trunk?

How Do I Delete Member Interfaces from an Eth-Trunk?

  1. Run the shutdown command in the interface view to configure the member interface to be deleted in Down state.
  2. Run either of the following commands to delete the member interface from the Eth-Trunk.
    • Run the undo eth-trunk command in the interface view.
    • Run the undo trunkport interface-type { interface-number1 [ to interface-number2 ] } &<1-8> command in the Eth-Trunk interface view.
  3. Run the undo shutdown command in the interface view to configure the member interface to be deleted in Up state.
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 297209

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next