No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VBST

Configuring VBST

After you configure the operation mode of VBST and start VBST, VBST calculates the spanning tree and prunes a network into a tree network to eliminate loops. Network planners can also set parameters such as the switch priority, port path cost, and port priority to adjust the spanning tree calculation result.

Pre-configuration Tasks

Before configuring basic VBST functions, connect ports and set the physical parameters of each interface to make the physical layer in Up state. For details, see Basic Configuration for Interfaces and Ethernet Interface Configuration in the S7700 and S9700 V200R011C10 Configuration Guide - Interface Management.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 298252

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next