No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switching to the RSTP Mode

Switching to the RSTP Mode

Context

If an interface on an RSTP-enabled device is connected to an STP-enabled device, the interface switches to the STP compatible mode.

If the STP-enabled device is powered off or disconnected from the RSTP-enabled device, the interface cannot switch back to the RSTP mode. In this case, run the stp mcheck command to switch the interface to the RSTP mode.

You need to manually switch the interface to the RSTP mode in the following situations:

  • The STP-enabled device is shut down or disconnected.

  • The STP-enabled device is switched to the RSTP mode.

Procedure

  • Switching to the RSTP mode in the interface view
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of an interface participating in spanning tree calculation is displayed.

    3. Run stp mcheck

      The interface is switched to the RSTP mode.

  • Switching to the RSTP mode in the system view
    1. Run system-view

      The system view is displayed.

    2. Run stp mcheck

      The device is switched to the RSTP mode.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 287370

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next