No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R011C10

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VLANIF Interface Corresponding to a Super-VLAN

Configuring a VLANIF Interface Corresponding to a Super-VLAN


The IP address of the VLANIF interface associated with a super-VLAN must contain the subnets that users in sub-VLANs belong to. All the sub-VLANs will use that IP address to conserve IP addresses.


  1. Run system-view

    The system view is displayed.

  2. Run interface vlanif vlan-id

    A VLANIF interface is created for a super-VLAN, and the view of the VLANIF interface is displayed.

  3. Run ip address ip-address { mask | mask-length }

    An IP address is assigned to the VLANIF interface.

Updated: 2019-10-18

Document ID: EDOC1000178310

Views: 298030

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next