No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - MPLS

S7700 and S9700 V200R011C10

This document describes MPLS configurations supported by the switch, including the principle and configuration procedures of static LSPs, MPLS LDP, MPLS TE, MPLS QoS, MPLS OAM, Seamless MPLS, and MPLS common features, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Priority Mapping for the Public Tunnel

Setting the Priority Mapping for the Public Tunnel

Context

To map priorities of incoming packets to PHBs and colors based on the mappings defined in a DiffServ domain, bind the DiffServ domain to the inbound interface of the packets. The system then maps priorities of packets to PHBs and colors based on the mappings in the DiffServ domain.

To map PHBs and colors of outgoing packets to priorities based on the mappings defined in a DiffServ domain, bind the DiffServ domain to the outbound interface of the packets. The system then maps PHBs and colors of outgoing packets to priorities based on the mappings in the DiffServ domain.

NOTE:

Priority mapping must be configured before the public tunnel is set up. If priority mapping is configured after the public tunnel is set up, you must restart MPLS LDP; otherwise, the setting cannot take effect.

Procedure

  • Perform the following steps on the ingress node.
    1. Run system-view

      The system view is displayed.

    2. Run mpls-qos ingress { use vpn-label-exp | trust upstream { ds-name | default | none } }

      The PHB/color of packet is mapped to the EXP priority of the public tunnel on the ingress node.

      By default, mapping from the PHB/color to the EXP priority of the public tunnel is performed according to the settings in the default domain.

      If you want to perform priority mapping based on the EXP priority of the private tunnel, specify the vpn-label-exp parameter in the command.

      NOTE:

      After you configure the mpls-qos ingress none command, the E series cards (except the EH1D2X48SEC0 card) map PHB/color of packet to 802.1p and DEI values based on the configuration of the outbound interface, and the other cards set the 802.1p and DEI values to 0.

  • Perform the following steps on the transit node.
    1. Run system-view

      The system view is displayed.

    2. Run mpls-qos transit trust upstream { ds-name | default | none }

      Priority mapping is performed based on the EXP priority of the public tunnel on the transit node.

      By default, mapping of the EXP priority of the public tunnel is performed according to the settings in the default domain.

  • Perform the following steps on the egress node.
    1. Run system-view

      The system view is displayed.

    2. Run mpls-qos egress trust upstream { ds-name | default | none }

      The EXP priority of the public tunnel is mapped to the PHB/color on the egress node.

      By default, mapping from the EXP priority of the public tunnel to the PHB/color is performed according to the settings in the default domain.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178315

Views: 118494

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next